Engine Raising Kit - BMW R45, R50, R60, R65, R75, R80, R90, R100 / EnDuraLast

Home > Airhead > Engine & Drivetrain > Engine > Engine Block > Engine Block 1980-1996 Models >

46 71 1 230 762,46711230762,R45 engine bolt,R50 engine bolt,R60 engine bolt,R65 engine bolt,R75 engine bolt,R80 engine bolt,R90 engine bolt,R100 engine bolt

Alternative Views:

Part #: EngBoltKit

Engine Raising Kit for enhanced corning.

.The CNC machined aluminum raising kit will raise the engine by around 30mm - simple bolt on kit not requiring any welding.

The assembly MUST be carried out by an experienced specialty shop.

Vehicle Manufacturer: BMW
Application: BMW Airhead Models
Make/Model: BMW R45, R50, R60, R65, R75, R80, R90, R100
Model Years: 1969 - 1995

(See APPLICATION TABLE tab BELOW to verify vehicle fitment)

Brand :

List Price $348.00

USD Price $266.50

Quantity in Stock:2

Part #: ENGBOLTKIT

Quantity:

Description

Application Table

Assembly Instructions

Drill 4 holes (35-40 mm deep) for the full floating axle using a 14.5 mm drill.
Cut a thread (26 mm deep) in the block using a M16 x 1.5 screw tap.
Screw-in the four M12 / L22 threaded inserts (included in the scope of supply) on the inner side (up to 4mm below the upper edge of the motor housing) and fix with a screw locking liquid e.g. Loctite 270.
Fix the elevation set on the housing with hexagonal screws and verify the width; nominal width = 190 mm. If required, polish and smoothen out the interfering weld seams on the inner side of the frame.
Now, mount the motor in the frame.
Depending upon the model, one of the four original spacer sleeves (no longer required afterwards) on the left side between the frame and motor is approx.3 mm longer. Adjust this distance at the corresponding point.
Screw-in the four M12x1.5 hexagonal screws up to 60mm and tighten them with the tightening torques given in the manual.

The assembly MUST be carried out by an experienced specialty shop.